Remove old coating and silicone, deep clean the surface, repair defects, and let it dry completely. Sand thoroughly, wipe away all dust, and mask the surrounding area.

The surface must be clean and completely dry before coating.

Pour Part B hardener into Part A base. Stir for 5–8 minutes, let the mixture stand for 5–10 minutes to release bubbles, then stir again for 1 minute. For a partial batch, maintain the 4:1 ratio by weight.

Use the mixed coating within approximately 40 minutes.

Pour from the top rim so the coating flows down the surface. Use the serrated plastic spreader for a thin, even layer, the mini foam roller on the bottom and flat areas, and the brush for corners and detail areas.

Work evenly and remove excess coating before it begins to set.

Keep the area ventilated and protect the coated surface from water, cleaners, dust, and contact while the high-gloss finish cures.

Touch-dry: 24 hours · Light use: 36–48 hours · Full cure: 7 days.